Extron Electronics FOX 3G DVC User Guide - Manual (Page 10)

FOX 3G DVC • Installation 4
Installation
This section gives an overview of the steps for installing the FOX 3G DVC. It also provides a
description of the rear panel connectors and instructions for cabling. Topics include:
• Installation Overview
• Rear Panel
• Daisy-chain Connection
• Connecting for Remote Control
Installation Overview
CAUTION: Installation and service must be performed by authorized personnel only.
Follow these steps to install and set up the FOX 3G DVC:
1. Disconnect power from the converter and ensure that all other devices that will be
connected to it are powered off.
2. (Optional) Mount the unit in a rack or to furniture (see “ Mounting the
FOX 3G DVC Converter ” in the “Reference Information” section).
3. Connect the input. Connect an SDI, HD-SDI, or 3G-SDI source to the fiber optic LC
Input connector ( c in figure 2 on the next page).
4. (Optional) Daisy-chain additional FOX 3G devices. Connect another
FOX 3G DVC or a FOX 3G HD-SDI to the Buffered Loop-Through (Tx) port of the input
connector (
b in figure 2). (Up to three devices can be daisy-chained from this port.)
5. Connect the video output. Connect a display or other output device to one of the
following connectors:
• DVD-D — Digital video ( e in figure 2)
• RGB/R-Y,Y,B-Y — Analog RGB (RGBHV, RGBS, and RGsB) or YUV component video
(
f in figure 2)
6. Connect the audio output. Connect an amplifier or other audio output device to the
5-pole captive screw audio connector (
g in figure 2).
7. Connect a control device. Connect a computer or control system to one of the
following DVC ports to configure and control the converter via SIS commands.
• Config port (front panel) — USB connection ( a in figure 9, “ Operation ”
section)
•
RS-232 port (rear panel) — Serial RS-232 connection ( h in figure 2)
NOTE: See “ Command and Response Table ” in the “Remote Configuration
and Control” section for definitions of the SIS commands .
8. Plug a standard IEC power cord (provided) into the power receptacle ( a in figure 2).
Connect the DVC to a 100 to 240 VAC, 50-60 Hz AC power source.
9. Configure the FOX 3G DVC as needed, using the front panel menus (see “ Menus on
the LCD Screen ” in the “Operation” section) or SIS commands (see the “ Remote
Configuration and Control ” section).