beautypg.com

To replace the system – Extron Electronics Cable Retraction System User Guide User Manual

Page 32

background image

26

Cable Retraction System • Maintenance and Adjustments

26

5.

Slowly lower the system and allow it to hang vertically. If the system was mounted
vertically, it is already in this position.

6.

Make certain the retractors are supported so they will not drop unexpectedly.

CAUTION: All retractors attached to the enclosure mounting bolt will drop when

the enclosure mounting bolt is removed.

7.

Remove the enclosure mounting bolt. The retraction system is now detached from the
Cable Cubby.

Remove enclosure
mounting bolt.

Support the
retraction system.

Slide system
down and out.

7

6

8

Figure 27.

Removing the Cable Retraction System

8.

Slide the system down and out to remove it from the Cable Cubby.

To Replace the System:

Reverse the previous steps making certain the system is correctly oriented to the Cable
Cubby enclosure.