Extron Electronics Cable Retraction System User Guide - Manual (Page 10)

Cable Retraction System • Before Getting Started 4
Planning
The cable retraction system can be mounted horizontally or vertically depending upon
under-table clearance and accessibility.
Horizontal mounting is recommended to provide maximum legroom and to protect the
retractors against accidental damage.
Vertical mounting is used where insufficient under-table space exists for horizontal
mounting or where under-table access is limited.
Angular mounting (XL models only) is used where insufficient under-table space exists
for horizontal mounting and tabletop to floor clearance prevents vertical mounting. The
XL enclosure has additional mounting holes that enable mounting at an angle between
horizontal and vertical.
• For horizontal mounting, a mounting
bracket kit, part number
70-678-00, is
required (see Optional Accessories on
page 29).
• Filler modules, part number 70-678-08,
may be required to occupy unused retractor
space (see
Optional Accessories on
page 29).
• For Cable Cubby 200 installation, obtain
the CC 200 bracket kit (see
Optional
Accessories on page 29).
• For DC Power retractors, refer to the list on
the website for laptop compatibiiity. Always
use a power supply recommended by the laptop manufacturer.
UNSWITCHED
100-240V/ 5AMAX
UNSWITCHED
USP HUB4 AAP
AC
TIVITY
100-240V/ 5AMAX
Check for adequate cable
clearance inside the
Cable Cubby enclosure.
Retractors take
two AAP spaces.
Filler modules
(part #
70-678-08)
take up the same
space as one retractor.
CC 800 shown
The retraction system must be mounted on either
side of the enclosure with the cable release buttons
against the enclosure side walls.
Figure 3. Retraction System Enclosure Locations
NOTE: When AAP modules are relocated or removed to provide space for the retraction system,
associated AAP brackets may require reconfiguration or replacement. Before starting an
installation determine if replacement AAP brackets will be needed. Replacement brackets can be
ordered from the Extron website.
(x4)
Horizontal Mounting
Bracket (Optional)
Part 70-678-00
Filler Module
(Optional)
Part 70-678-08
CC 200 Mounting Bracket
for Cable Cubby 200
(Optional)
Part 70-678-10