beautypg.com

Prepare the cable cubby enclosure, All installations, Retrofit installations – Extron Electronics Cable Retraction System User Guide User Manual

Page 15: All installations retrofit installations

background image

Cable Retraction System • Before Getting Started

9

Prepare the Cable Cubby Enclosure

DANGER: SEVERE ELECTRICAL SHOCK. Remove all power from the Cable

Cubby enclosure before beginning a retraction system installation.

All Installations

By now you should be certain the retraction system has adequate under-table clearance
for installation and that proper legroom will be provided to avoid accidental contact with the
system. You should have the required accessories for mounting the retraction system along
with the necessary AAPs and AAP brackets to reconfigure the enclosure.
The retraction system requires two adjacent AAP spaces and must be installed on one side
of the enclosure or the other with the cable release buttons against the enclosure side walls
(see figure 8). Filler modules, when used, take up the same space as one retractor. Where
the retraction system is installed in the enclosure is based on under-table clearance, the
mounting orientation of the retractors, and operation preferences.
Install or reconfigure the power module and AAP modules and brackets before beginning
the installation of the retraction system.

Retrofit Installations

Prepare the AAP spaces for the retraction system ensuring sufficient under-table clearance
for the retraction system.
Relocate, remove, or replace existing AAPs and reconfigure associated AAP brackets to
make room for the retraction system.

UNSWITCHED

100-240V/ 5AMAX

UNSWITCHED

USP HUB4 AAP

AC
TIVITY

100-240V/ 5AMAX

Check for adequate cable

clearance inside the

Cable Cubby enclosure.

Retractors take

two AAP spaces.

Filler modules
(part #

70-678-08)

take up the same
space as one retractor.

CC 800 shown

The retraction system must be mounted on either

side of the enclosure with the cable release buttons

against the enclosure side walls.

Figure 8.

Retraction System AAP locations