beautypg.com

Cc 200 bracket and retractor mounting, E (see, Cc 200 bracket and – Extron Electronics Cable Retraction System User Guide User Manual

Page 19: Retractor mounting

background image

Cable Retraction System • Installation

13

CC 200 Bracket and Retractor Mounting

1.

Using the supplied mounting bolt (1/4-20 x 3 inch), mount the CC 200 bracket to the
retractor as shown.

NOTE: If only one retractor is mounted, use a filler module (part number

70-678-08) in place of the second retractor.

Once the retractor is mounted to the bracket, the assembly may be installed.

2.

The cable stops and connectors may be too large to fit through the AAP opening at the
same time as the retractor. Pull a short amount of cable out of the retractor and push it
through the AAP opening prior to installing the bracket and retractor assembly.

Mounting Screw

w / Washer (4 plcs)

Mounting Bolt

and Nut

CC 200

Bracket

1

3

2

Bracket and
Retractor Assembly

Figure 12.

Install the Bracket and Retractor Assembly

3.

Press the bracket and retractor assembly against the bottom of the enclosure, lining up
the bracket holes with the AAP mounting holes on the enclosure. Fasten from the top
using the four supplied screws.

4.

See

Locking Screw (Optional)

on page 17

for final installation instructions.