Extron Electronics Cable Retraction System User Guide - Manual (Page 18)

Cable Retraction System • Installation 12
Cable Cubby 200
The CC 200 Mounting Bracket, part number 70-678-10,
allows one or two retractors (standard or XL) to be installed in
a Cable Cubby 200 enclosure. The bracket kit adapts an AAP
opening for retraction system mounting similar to other Cable
Cubby enclosures.
Before installing the adapter, be certain there is adequate space
under the table for the retraction system with the attached
bracket.
NOTE: To prevent objects from impeding cable retraction,
ensure at least 3 inches of clearance from the exposed
cable side of the retractor enclosure.
Determine the retractor mounting orientation: horizontal, vertical, or angular (see Planning
on page 4).
CC 200 Mounting
Bracket Kit
(x4)
CC 200 Bracket
3.0" (7.6 cm)
3.0" (7.6 cm)
CC200 Horizontal Mounting Clearance
XL Models
15.7" (39.9 cm)
21.8" (55.3 cm)
8.9" (22.6 cm)
Standard Models
8.9" (22.6 cm)
CC 200 Bracket
3.0"
(7.6 cm)
0.3" (7.6 mm)
2.0" (5.0 cm)
23.3" (59.1 cm)
10.7" (27.2 cm)
30
CC 200
Vertical Mounting Clearance
Standard Models
XL Models
27.5"
(69.9 cm)
Figure 11. CC 200 mounting dimensions