All installations (except drop-in) – Extron Electronics Cable Retraction System User Guide User Manual
Page 14
Cable Retraction System • Before Getting Started
8
All Installations (Except Drop-in)
Horizontal Mounting: Be certain the horizontal mounting bracket can be fastened
under the table or on a table support without bending the pulley system or forcing it from
perpendicular with the enclosure (see figure 7, “Top View”).
Vertical Mounting: Ensure the retraction system will hang freely without touching the
floor and is not obstructed by anything under the table (see
TLP 350CV, TLP 710CV, TLE 350, TLE 710
Angular Mounting (XL models only): For installations where the tabletop is less than
30 inches from the floor, the XL retractor system is too long for vertical mounting and there
may not be adequate under-table clearance for horizontal mounting. An additional mounting
hole has been provided for these installations that allow the retractor system to install at an
angle providing extra floor clearance (see figure 7, right).
Top View
Horizontal
Bracket
UNSWITCHED
100-240V/ 5AMAX
UNSWITCHED
USP HUB4 AAP
AC
TIVITY
100-240V/ 5AMAX
CC800
29.3"
(74.4 cm)
28.0"
(71.1 cm)
Floor
26.6"
(70.1 cm)
10.6"
(27.0 cm)
30
1.9"
(4.7 cm)
XL Models Vertical Clearance -
Angular and Vertical Mounting
For minimum table height
requirements of 28 inches
(71 cm) specified by ADA
Section 4.32.
CC800
Figure 7.
Horizontal Bracket (Top View) and XL Models Vertical Clearance