Hold the cable to prevent movement – Extron Electronics Cable Retraction System User Guide User Manual
Page 30
24
Cable Retraction System • Maintenance and Adjustments
24
2.
Hold the cable to prevent movement.
Adjust.
2
3
Hold cable.
1
Cable stop collar
(or connector on
some models) must
be seated.
Loosen thumbwheel
nut.
Align pulley screw.
4
Retainer Clip
Adjust.
2
3
Hold cable.
1
Cable stop collar
(or connector on
some models) must
be seated.
Loosen thumbwheel
nut.
Align pulley screw.
4
Retainer Clip
Figure 23.
Pulley System Adjustment
3.
Loosen the thumbwheel nut on the retainer clip until the cable can be moved. Do not
allow it complete freedom of movement.
4.
Adjust the cable to align the bottom pulley screw with the alignment hole on the
enclosure (designated
c
on the product label in figure 24).
33-1810-10
Rev. A
Anaheim, CA USA
www.extron.com
Cable Retractable System
The cable and spring assembly have been
tested and optimized for this model.
Contact Extron Electronics for modifications
or repairs.
WARNING!: When retracting, hold the cable end as
the release button is pressed. Restrict
the retraction to a slow, controlled motion.
Keep hands and fingers away from
moving parts.
Do not operate retractor until installed.
NOTE: To prevent objects from impeding
cable retraction, ensure at least
three inches of clearance from the
exposed cable side of the enclosure.
Cable Tension Adjustment
For optimum performance, proper cable tension must be
maintained. Follow the steps below or refer to the
Cable
Retractable System User Guide for procedures.
1. Hold the cable to prevent movement.
2. Loosen thumbwheel nut on cable retainer.
3. Adjust cable to align tension pulley screw to this hole.
4. When tension is correct, re-tighten the thumbnut to
secure the cable.
c
Alignment
Hole
For horizontal mounting
remove this screw (each side).
DO NOT remove
pulley screws
(each side).
Hold cable.
a
Loosen thumbwheel nut.
b
Alignment Hole (pulley screw visible)
Figure 24.
Product Label on Retractor
5.
Hand tighten the thumbwheel nut on the retainer clip to secure the cable.