Extron Electronics Cable Retraction System User Guide - Manual (Page 21)

Cable Retraction System • Installation 15
Horizontal Bracket Mounting
For horizontal mounting, the horizontal mounting bracket (part number 70-678-00) must be
used. The slotted holes in the mounting bracket allow for tolerance in placing the bracket.
To ensure accurate bracket location, follow these procedures:
1. Attach the horizontal mounting bracket to the retractor end caps using the provided bolt
and nut.
TIP: Hand tighten the nut only enough to keep the bracket from easily moving.
The bolt and nut will be removed later.
Horizontal Bracket
Mounting Holes
Horizontal Mounting
Bolt
End Caps
Slotted Hole
Figure 14. Attach Horizontal Bracket to End Caps
2. Raise the retraction system with attached bracket to the desired mounting location.
NOTE: Be certain the system is perpendicular to the enclosure to prevent
binding of the pulley system.
Top View
Horizontal
Bracket
UNSWITCHED
100-240V/ 5AMAX
UNSWITCHED
USP HUB4 AAP AC
TIVITY
100-240V/ 5AMAX
CC800
Figure 15. Align Retraction System Perpendicular to Cable Cubby Enclosure