Extron Electronics Cable Retraction System User Guide - Manual (Page 13)

Cable Retraction System • Before Getting Started 7
TLP 350CV, TLP 710CV, TLE 350, TLE 710 Enclosure Clearances
The following diagrams show the clearance dimensions required for mounting a retractor
system in a TouchLink (TLP 350CV and TLP 710CV only) or the TLE series enclosures.
Horizontal Mounting Clearance
TLP 350CV/710CV TLE 350/710
XL Models
10.0"
(25.4 cm)
15.7"
(39.9 cm)
16.7"
(42.5 cm)
3.0"
(7.6 cm)
10.0"
(25.4 cm)
21.7"
(55.0 cm)
23.0"
(58.5 cm)
3.0"
(7.6 cm)
See
Table A
1.9" (4.8 cm)
24.3"
(61.7 cm)
1.9" (4.8 cm)
30.3"
(77.0 cm)
Vertical Mounting Clearance
TLP 350CV/710CV TLE 350/710
XL Models
See
Table B
Figure 6. Vertical and Horizontal Clearance Requirements, TLP 350CV, TLP
710CV, TLE 350, and TLE 710
Retractor installation into the TLP and TLE enclosures is identical to the standard Cable
Cubby enclosures. The enclosures are one inch longer than the CC 300/600/800
enclosures, but otherwise the dimensions are the same.
NOTE: Angular mounting requires an additional inch of floor clearance compared to
the Cable Cubby enclosures.
Enclosure Model Dimension
TLP/TLE 7.4 inches (18.8 cm)
Table A. Vertical Dimension from Table Top To Pigtail
(Horizonal Mounting)
Enclosure Model Dimension
TLP/TLE 10.5 inches (29.2 cm)
Table B. Vertical Dimension from Table Top To Pigtail
(Vertical Mounting)