Extron Electronics Cable Retraction System User Guide - Manual (Page 26)

Cable Retraction System • Installation 20
Connect the Cables
Connect the under-enclosure cables to the proper device.
If additional cable length is needed use Extron cable as required.
Excess cabling may cause clearance issues. Use wire ties to secure under-table cabling to
prevent accidental contact or entanglement with users.
Verify Cable Release Operation
After installation, check the operation of the cable release assembly. Pull a length of cable
from the system. The cable release button stops the cable from retracting back into the
system when pulling ceases.
Make certain the cable pulls freely without jerking or requiring excessive force. If it does,
check under the enclosure to determine if something has fallen into the retraction system
to cause tangling of the cable or is jamming the pulley
system. Also be certain the cable is properly routed
around the pulleys (see figure
22 on page 20).
Release the cable. Hold the connector and press the
release button. When retracting, hold the cable end
as the release button is pressed. Restrict the cable
retraction to a slow, controlled motion.
Ensure the cable retracts completely into the system.
The stop collar (or connector if there is no stop collar)
will rest on the seat of the cable stop assembly, stopping
cable travel. If it does not, proceed to
Pulley System
Adjustment on page 23.
Stop collar
seated.
Cable Release
Assembly
Cable Release
Button