Extron Electronics FOX Matrix 7200 - Manual (Page 81)

3. Select the desired software or firmware file to download and click Download .
TIP: Click the desired Filter By: letter to jump to the correct page of downloads.
4. Enter the requested personal information;
TIP: Click Remember Me to eliminate step 4 in future downloads.
5. Click Download to copy the software or firmware to your computer.
6. Click Run to confirm that you want to run the installation.
7. For a firmware download, exit this procedure and return to Updating the Firmware
on page 80 or Firmware Upgrade Page on page 105.
8. Follow the on‑screen instructions. The installation creates a C: \ Program Files \ Extron \
Matrix_Switchers directory, and it places the following four icons into a group folder
named “ Extron Electronics \ Matrix Switchers ” :
NOTE: The folder is C: \ Program Files(x86)\ ... for Windows 7 or Windows 8.
• MATRIX Switcher + Control Program
• MATRIX Switcher + Help
• Check for Matrix Updates
• Uninstall MATRIX Switcher
Using the Matrix Switcher Control Software
Many items found in the Matrix Switchers Control Program are also accessible via front
panel controls (see
Front Panel Operations on page 25) and under SIS control (see the
Programming Guide section, beginning on page 52).
1. To run the Matrix Switchers Control Program, click
Start > Programs > Extron Electronics > Matrix Switchers >
MATRIX Switcher + Control Pgm .
The Comm Port Selection window (see figure 32) appears.
Figure 32. Comm Port Selection Window
2. Choose either the Comm port that is connected to the rear panel Remote port or front
panel Config (RS‑232) port,
IP [LAN] , or Emulate .
• If you selected a comm port, check the baud rate displayed in the comm port
selection dialog box.
NOTE: To change the baud rate, click the Baud button and
double‑click the desired baud rate. The default is 9600.
FOX Matrix 3200 and 7200 Switchers • Matrix Software 73