Extron Electronics FOX Matrix 7200 - Manual (Page 53)

Performing Soft System Resets (Resets 3, 4, and 5)
Perform a soft reset of the switcher as follows:
1. Use an Extron Tweeker or other small screwdriver to press and hold the rear panel
Reset button until the front panel View and Esc buttons blink the number of times for
the desired reset: once (events reset), twice (system reset), or three times (absolute
reset) (see figure 26).
RESET
RESET
RESET
CONTROL
T
CONTROL
CONTROL
T
T
ESC VIEW
ESC VIEW
ESC VIEW
Release, then immediately
press and release again.
6 seconds
9 seconds
Press and hold
the Reset button.
3 seconds
View and Esc buttons blink once.
Reset LED blinks once.
Release, then immediately
press and release again.
Reset LED blinks twice.
Press and hold
the Reset button.
Press and hold
the Reset button. Reset LED blinks
three times.
View and Esc buttons blink twice.
View and Esc buttons blink three times.
IP Settings
Reset
Absolute
Reset
Events
Reset
(Mode 5)
(Mode 4)
(Mode 3)
Release, then immediately
press and release again.
Figure 26. Soft System Resets
2. Release the Reset button and then immediately press and release the Reset button
again. Nothing happens if the second momentary press does not occur within 1 second.
FOX Matrix 3200 and 7200 Switchers • Operation 45