Xylem H-3531 FlashLite - Manual (Page 26)

4-2 Simple RS-232 Menu Interface
H-3531
4.2 General Operations
The H-3531 FlashLite™ settings can be made either via the Simple Menu or with extend SDI-12
commands. This chapter focuses on the Simple Menu interface.
The menu displays a list of available options. The right column is status information and cannot
be edited. At the bottom of the screen is an “
Enter Option > ” prompt. Enter the desired menu
option here, the ENTER key does not have to be pressed.
Some options, when selected act as a toggle and will change when selected. These options only
have two choices such as: On/Off. Options with brackets
“[ ]” allow the user to set or
change a value. After entering the requested value within the brackets, press ENTER to make the
change. If you do not want to edit the option that has been selected, press the ESC key and the edit
will be aborted.
4.3 Menu Options
4.3.1 P - Sensor Mode Options
In this sub-menu you can view the current H-3531 FlashLite™ power mode settings or
other modes if available and change the modes if desired. Refer to section 4.4 for the
Sensor Mode Options sub-menu options.
4.3.2 V - Sensor Output Options
In this sub-menu you can view the current H-3531 FlashLite™ output options and enables.
In this sub-menu you can change these options and enables. Refer to section 4.5 for the
Sensor Output Options menu options.
H-3531 FlashLite Interface Menu
P - Sensor Mode Options Serial#: 001000
V - Sensor Output Options Version: 1.90
B - H-355 Bubbler Options Temp: +72.2
A - SDI-12 Address: 0 Battery: +13.8
S - Stage: +46.13
D - Digits: +2
O - Offset: +0.0000
U - Units: Feet
L - Slope: +2.30670
C - Averaged Measurements: +8 (+6 sec)
M - Measure
H - H-355 Bubbler: Off
X - Exit
Enter Option >