Xylem MultiLab 4010-2 - Manual (Page 84)

Transmitting data MultiLab 4010-2
84 ba76142e01 05/2013
11.5 Options for data transmission to the USB-B (PC)
interface and the USB-A (USB printer) interface
Via the USB-B interface you can transmit data to a PC.
Via the USB-A interface, you can transmit data to a USB printer or USB mem-
ory device. How to transmit data to a USB memory device is described in an
extra section (see section 11.6 D
ATA TRANSMISSION TO THE USB-A INTERFACE
(USB MEMORY DEVICE ), page 85).
The following table shows which data are transmitted to the interface in which
way:
Data Control Operation / description
Current
measured
values of all
connected
sensors Manual  With .
 Simultaneously with every manual data storage process (see
section 10.1 M
ANUAL DATA STORAGE , page 76).
Automatic, at
intervals  With
_
>.
Then you can set the transmission interval.
 Simultaneously with every automatic data storage process (see
section 10.2 A
UTOMATIC DATA STORAGE AT INTERVALS , page 76).
Stored mea-
sured values Manual  Displayed dataset with after calling up from the storage.
 All datasets with the Output to RS232/USB function.
(see section 10.3.1 E
DITING THE MEASUREMENT DATA STORAGE ,
page 79).
 All datasets with the Output to USB flash drive or printer function
(USB-A interface)
For details, see section 10.3.1 E DITING THE MEASUREMENT DATA
STORAGE
, page 79.
Calibration
records Manual  Displayed calibration record with (see section 5.2.6 C ALI -
BRATION DATA , page 36; section 7.2.6 C ALIBRATION DATA , page
53; section 8.3.4 C ALIBRATION DATA , page 59).
 All calibration records with the Output to USB flash drive or
printer function.
 All calibration records with
_
>.
For details, see section
11 T RANSMITTING DATA , page 82.
Automatic  At the end of a calibration procedure.
The following rule applies: With the exception of the menus, shortly
pressing the key generally outputs the display contents to
the interface (displayed measured values, measurement datasets,
calibration records).