Armasight DARDROPBB05PAL1 Drone Pro 5x Digital Night Vision Riflescopes - Manual (Page 31)

31
CAUTION:
DO NOT leave the IR illuminator activated if it is not being used.
Operate the IR illuminator as follows:
1. After examining a scene with the Drone PRO, turn the IR illuminator on.
2. To change the radiated power level, turn the power switch to one of the spots between the two OFF
positions.
3. To adjust IR beam divergence, turn the lens.
4. To adjust the IR spot position in the field of view, loosen the clamp screw and tilt the IR illuminator as
required in the spherical clamp hinge. Tighten the screw using a 2.5 mm hex key.
3.3.4 DRONE PRO SHUT-DOWN
NOTE:
Shut down the Drone PRO properly to avoid losing unsaved settings and data.
Shut-down the Drone PRO as follows:
1. Be sure to save your settings.
2. Turn off the Drone PRO.
3. Replace the cap on the objective lens.
4. Disconnect the cable (if applicable).
5. Place the cap on the connector.
6. Dismount the Drone PRO from the weapon.
7. Remove the batteries.
CAUTION:
Do not store the Drone PRO with the batteries still installed.
8. Store the Drone PRO and all accessories in the carrying case.