Armasight DARDROPBB05PAL1 Drone Pro 5x Digital Night Vision Riflescopes - Manual (Page 26)

26
ITEM NO. FUNCTION DESCRIPTION
4
RETICLE PATTERNS
CONTROL
Quickly push the button (4) to switch between available reticle pat-
terns: “Dot”, “Small Crosshair”, “Big Crosshair”, “Crosshair with Dot”,
“Circle”, “Circle with Dot”, or “No Reticle”.
To save your preference, push buttons (2) and (4) simultaneously.
SAVE should appear in the display.
5
BORESIGHT ADjUSMENT
(uses in combination
with other buttons)
While holding down the button (5), push the buttons:
- (1)/(3) to shift the reticle in the display up/down,
- (2)/(4) to shift the reticle to the right/left, respectively.
To reset to zero azimuth and elevation, push the combination of
buttons (1+3). The reticle will shift in the display center. The ZERO
indication will appear in the display.
After completing your customization, save your preference by push-
ing buttons (2) and (4) simultaneously. SAVE should appear in the
display.
3.2.2 IR ILLUMINATOR CONTROLS
The controls of the optional IR illuminators are shown in Figure 3-14 and defined in Table 3-3. The ITEM
NO. column indicates the number used to identify items in Figure 3-14.
1
2
FIGURE 3-14. IR ILLUMINATOR CONTROLS
TABLE 3-3. IR ILLUMINATOR CONTROLS
ITEM NO. FUNCTION DESCRIPTION
1 POWER SWITCH
Switches the IR illuminator on/off and adjusts for radiated power.
Four ON positions are located between the two OFF positions, and
are each marked with a different-sized spot. The larger the spot, the
greater the radiated power.
2 LENS FOCUS
Adjusts for IR beam divergence. Adjustment range is covered with
approximately one turn of the lens.
TABLE 3-2. CONTINUED