Armasight NSCCOMINI139DA1 CO-Mini GEN 3+ Alpha MG Night Vision Mini Clip-On System - Manual (Page 7)

7
1
INTRODUCTION
1.1 GENERAL INFORMATION
1.1.1 TYPE OF MANUAL
Operation and Maintenance (including a List of Spare Parts).
1.1.2 MODEL NUMBER AND EqUIPMENT NAME
Armasight CO-MINI Night Vision Clip-On System.
Armasight CO-MINI MG Night Vision Clip-On System.
1.1.3 PURPOSE OF EqUIPMENT
The CO-MINI is a night vision system intended to be used for short to medium ranges (normally up to
350 yards) in conjunction with a daytime sight or riflescope (hereafter referred to as a “day scope”).
When mounted on a weapon in front of an existing day scope, the CO-MINI adds night vision function-
ality to the scope’s capabilities, without affecting the boresight.
The CO-MINI is compatible with most commercial and military specification day scopes or binoculars,
up to 6X magnification, and fits any Picatinny MIL STD 1913 or Weaver rail via the quick-release mount.
Optional adapters make it possible to mount the CO-MINI directly to the objective lens of a variety of
day scopes and binoculars.
A long-range IR850 illuminator (hereafter referred to as the IR850) enables use of the CO-MINI in ex-
tremely low light conditions or total darkness. Other additional equipment, such as an infrared laser,
red dot sight, etc., may also be installed on the CO-MINI.
Additionally, the CO-MINI MG version incorporates gain control, which allows the user to increase or
decrease the brightness of the image to compensate for overly bright or extremely dark conditions.
NOTE:
The CO-MINI can also be installed in front of the viewfinders of various instruments to widen
the operational illumination range.
1.1.4 REPORTING EqUIPMENT IMPROVEMENT RECOMMENDATIONS
Recommendations from the user for improvements to the device are encouraged.
Mail your comments to Armasight Inc., 815 Dubuque Avenue, South San Francisco, CA 94080, USA.
Or, send an email to [email protected].