Armasight NSCCOMINI139DA1 CO-Mini GEN 3+ Alpha MG Night Vision Mini Clip-On System - Manual (Page 16)

16
ITEM NO. DESCRIPTION qUANTITY
9 CR123А Battery
A single lithium battery used to power the CO-MINI. A single lithium battery used to
power the IR850. 2
10 Special Wrench
An instrument used for repositioning the adapter in the CO-MINI battery cap, de-
pending on the battery being installed. 1
11 Hard Case
A protective case used for shipping/storage of the CO-MINI and its accessories. 1
12 Operation and Maintenance Manual
Provides safety information, equipment description, mounting procedures, operat-
ing instructions, and preventive maintenance checks and services (including a List of
Spare Parts). 1
2.4 OPTIONAL EqUIPMENT
Optional items are shown in Figure 2-4 and listed in Table 2-10.
The ITEM NO. column indicates the number used to identify items in Figure 2-4.
The PART NO. column indicates the primary number used by the manufacturer to identify an item.
FIGURE 2-4. CO-MINI OPTIONAL EqUIPMENT
1 3 2 4 5 6
TABLE 2-10. CO-MINI OPTIONAL EqUIPMENT
ITEN NO. DESCRIPTION PART NO.
1 Raiser
Used when installing the CO-MINI in front of ACOG 4×32 scope. Raises the CO-
MINI above Picatinny/ Weaver rail for height alignment of the CO-MINI and day
scope optical axes. Furnished with two М4×18 flat head socket cap screws. ANAM000042
2 Light Suppressor 2
A rubber cup mounted to the CO-MINI output lens to reduce light scattering.
Used when installing the CO-MINI in front of an ACOG 4×32 scope. ANEC000006
3 Light Suppressor 3
A rubber cup mounted to the CO-MINI output lens to reduce light scattering.
Used when installing the CO-MINI in front of the day scopes having a lens hous-
ing outer diameter over the range of 47 to 50mm. ANEC000007
4 Scope Mounting System 1 #40
A mounting system used to install the CO-MINI on the lenses of specified day
scopes. Includes a clamp with inserts that will fit 25.4 and 30mm diameters. ANAM000009
TABLE 2-9. CONTINUED