Armasight NSCCOMINI139DA1 CO-Mini GEN 3+ Alpha MG Night Vision Mini Clip-On System - Manual (Page 22)

22
The fully assembled CO-MINI with the raiser is shown in Figure 3-8.
3. To install the CO-MINI on a Picatinny/ Weaver rail in front of ACOG 4×32 scope, refer to Part 3.1.3.
3.1.6 INSTALLING THE CO-MINI ONTO THE LENS OF A DAY SCOPE
To install the CO-MINI onto a day scope, use the optional adapters.
NOTE:
The attaching diameters of the adapters differ, and must fit with the day scope parameters
specified in Table 2-8 (Scope Mounting Systems Data).
NOTE:
The CO-MINI cannot be attached to the scope if there is a focus ring attached to the objective
lens’ housing.
CAUTION:
The Scope Mounting Systems are not recommended for installing the CO-MINI on firearms that
have vigorous recoil (0.308 Win or stronger).
Figure 3-9 shows the CO-MINI installed on the lens of a day scope.
To install the CO-MINI on the lens of a day scope, do the following (refer to Figure 3-10):
1. Using a 2.5mm Allen key, unscrew both М4×8 fixing screws on the CO-MINI mount. Remove the
mount from the seating rail and place it, along with the screws, into the storage case.
FIGURE 3-8. THE CO-MINI READY-ASSEMBLED WITH THE RAISER
FIGURE 3-9. THE CO-MINI INSTALLED ON THE LENS OF A DAY SCOPE