Asus GigaX2024B - Manual (Page 65)

GigaX2024B/M L2 Managed Switch CLI Manual
45
Syntax spanning-tree edge-port
Parameters edge-port the interface is attached to a LAN segment that
is at the end of a bridged LAN or to an end node
Command Mode Interface mode
No/clear
No spanning-tree edge-port
Show show spanning-tree port detail IFNAME
Default None or depends on ODM customer
Description Use the spanning-tree cost configuration command on the switch
stack or standalone switch to set the spanning-tree interface
attached to a LAN segment that is at the end.
Example ASUS(config-if)# spanning-tree edge-port
10.31 spanning-tree forward-time <4-30>
Syntax spanning-tree forward-time <4-30>
Parameters forward-time the bridge forward delay time (sec)
<4-30> Valid range is 4~30 secs
Command Mode Configure terminal mode
No/clear
No spanning-tree forward-time
Show show spanning-tree port detail IFNAME
Default 15 sec
Description Use the spanning-tree cost configuration command on the
switch stack or standalone switch to set the spanning-tree bridge
forward delay time (sec).
Example ASUS(config)# spanning-tree forward-time 15
10.32 spanning-tree hello time <1-10>
Syntax spanning-tree hello time <1-10>
Parameters hello hello BPDUs
time the interval (sec) between hello BPDUs
<1-10> valid range is 1~10 secs
Command Mode Configure terminal mode