Asus GigaX2024B - Manual (Page 218)

GigaX2024B/M L2 Managed Switch CLI Manual
198
discardall -> discard all frame is accepted
vlan-tagged-only -> only vlan-tag frame is accepted
Command Mode Interface mode
No/clear
show
show interface IFNAME
Default None or depends on ODM customer
Description Use the acceptable frame type configuration command on
the switch stack or standalone switch to set the type of the
acceptable
frame, for any kind of frame type is accepted or only vlan-tag
frame is accepted.
Examples ASUS(config-if)#acceptable frame-type all
15.11 duplex (full|half)
Syntax duplex (full|half)
Parameters full -> Port is in half-duplex mode
half -> Port is in full-duplex mode
Command Mode Interface mode
No/clear
no duplex
Show show interface IFNAME
Default The default is Full
Description Use the duplex interface configuration command on the switch
stack or on a standalone switch to specify the duplex mode of
operation for Fast Ethernet and Gigabit Ethernet ports. Use the
no form of this command to return the port to its default value.
Examples ASUS(config-if)# duplex full
15.12 flowcontrol (rx|tx|both) (on|off)
Syntax flowcontrol (receive|send|both) (on|off)
Parameters rx -> sets whether the interface can receive flow-
control packets from a remote device