Asus GigaX2024B - Manual (Page 40)

GigaX2024B/M L2 Managed Switch CLI Manual
20
Show show dot1x / show running-config
Default The default is global disable
Description Use the dot1x system-auth-control global configuration command
on the switch stack or on a standalone switch to globally enable
802.1X. Use the no form of this command to return to the default
setting.
Example ASUS(config)# dot1x system-auth-control
6.9 dot1x timeout (reauth-period| quiet-period|tx-
period| supp-timeout| server-timeout) TIMEVALUE
Syntax dot1x timeout (reauth-period| quiet-period|tx-period| supp-
timeout|server-timeout) TIMEVALUE
Parameters reauth-period -> number of seconds between
reauthentication attempts
quiet-period -> number of seconds that the system remains
in the quiet state following a failed authentication exchange with
the client
tx-period -> number of seconds that the system waits
for a response to an EAP-request/identity frame from the
client before retransmitting the request
supp-timeout -> number of seconds that the system waits
for a response from Authenticator to Supplicant
server-timeout -> number of seconds that the system waits
for a response from Authenticator to Authentication Server
TIMEVALUE: 1~65535 seconds
Command Mode Interface mode
No/clear
no dot1x timeout (quiet-period| reauth-period| server-timeout|
supp-timeout| tx-period)
Show show dot1x all / show dot1x interface IFNAME
Default reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds