Asus GigaX2008EX - Manual (Page 49)

39
GigaX2008EX L2 Managed Switch User Manual
5.3.2 Physical Interface Commands
[Admin] [Enable/Disable]
Displays the port admin status and allows user to turn the port on or off.
CLI command: l2 port admin
[Mode] [Auto/10M-Half/10M-Full/100M-Half/100M-Full/1G-Full]
Displays the current speed and duplex mode of the port. The speed and duplex
mode can be automatically detected when auto-negotiation is enabled on a port.
CLI command: l2 port autoneg
CLI command: l2 port speed <10/100/1000>
CLI command: l2 port duplex
[Flow Control] [Enable/Disable]
Displays the IEEE802.3x flow control setting of a port. Note that this flow control
is operating only in full duplex mode.
CLI command: l2 port flow
[Reload]
Restores the previous port settings from the configuration file.
CLI command: l2 port retrieve
5.3.3 Bridge Commands
[Show Trunk]
Displays a specific trunk group settings. User can create a new trunk group by
specify a unique trunk ID, a trunk name description, the port selection criterion
(rtag), and its trunk group member ports.
CLI command: l2 trunk show
[Create Trunk]
Creates a new trunk group by giving trunk ID, rtag, name, and port numbers.
CLI command: l2 trunk create
[Add/Remove Trunk]
Trunk group port members can be added to or removed from an existing trunk
group.
CLI command: l2 trunk add