Asus GigaX2008EX - Manual (Page 45)

35
GigaX2008EX L2 Managed Switch User Manual
5.1.1 Boot ROM Command Mode
During the POST process, you can enter a “Boot ROM Command” mode by pressing
key as shown in Figure 39.
Figure 39 shows dual images in the switch.
Enter the “?” key to show the help messages for all available commands.
Although the commands are helpful in some situation, we
STRONGLY suggest users not to use them if you donʼt know the
command function.
Figure 39. Boot ROM Command Mode
5.1.2 Boot ROM Commands
Type “?” in the boot mode to display the valid commands list.
Table 7. Boot ROM commands
Command Parameters Usage
a NONE Display MAC address
b Slot 0/1/a Change boot slot
c IP address Configure TFTP client IP address
g NONE Load and execute firmware
h NONE Display online help
m mask Configure network mask
p NONE Display current configuration
r NONE System reboot