Asus GigaX2008EX - Manual (Page 46)

36
GigaX2008EX L2 Managed Switch User Manual
5.2 Login and Logout
By typing “login” to enter the CLI mode, you have to give a valid user name
and password. As the first time login, you can enter “ admin” as the user name
and bypass the password. For security reason, please change the user name
and password after login. Once you forget the use name and password, you
may contact ASUS support team or erase the whole configuration file in the
Boot ROM Command mode. If you take the second choice, the whole system
configuration is lost at the same time. That is, you have to configure the switch
again.
You type “l
ogout” to leave the CLI mode safely. This action allows you to secure
the CLI mode. The next user has to do login again with authorized user name
and password.
5.3 CLI Commands
The switch provides CLI commands for all managed functions. The command
uses are listed in the categories as the WEB management interface. This way,
you can follow the instructions and set up the switch correctly as easily as using
WEB interface to configure the switch. “save” command is used to save the
configuration to flash. Some CLI command is only effective after “save” command
is executed.
Always use “?” to get the available commands list and help.
Always use “/” to get back to the root directory.
Always use “..” to get back to parent directory.
Type the command only to get help for the command
Command Parameters Usage
s IP address Configure TFTP server IP address
t NONE Toggle safe mode
u File name Upload boot module/firmware via network
using TFTP protocol
v NONE Display boot rom version
w NONE Toggle administrator password reset