Asus P/I-P65UP8/CP6ND - Manual (Page 75)

ASUS P/I-P65UP8 User’s Manual 75
V. SCO UNIX DRIVERS
DURING KERNEL REBUILD, AN ERROR MESSAGE INDICATES THE
CHARACTER DEVICE NUMBER OF DEVICE cn CONFLICTS WITH THE
CHARACTER DEVICE NUMBER OF bhba OR slha
a Reinstall the proper Symbios Logic driver using the installpkg utility. Re-
member to relink the kernel.
b Reboot the system.
DURING INSTALLATION, THE ROOT DISK IS NOT FOUND, OR THE
PARTITIONING OF THE DISK FAILS
a If your boot drive is a SCSI disk, check that it is assigned SCSI ID 0 (zero),
and is configured to host adapter 0 (zero), LUN 0 (zero).
b If a SCSI tape drive is used in the initial installation:
Check that the tape drive is assigned SCSI ID 2, and that it is configured to
host adapter 0 (zero), LUN 0 (zero).
Check that the ID of the tape drive does not conflict with any other SCSI
device ID.
c If a SCSI CD-ROM drive is used in the initial installation:
Check that the CD-ROM drive SCSI ID is set to 5, and that it is configured to
host adapter 0 (zero), LUN 0 (zero).
Check that the ID of the CD-ROM drive does not conflict with any other SCSI
device ID.
d During installation, you are given the option of retaining current partitions on
the root hard disk. For instance, you could have a DOS partition or a user
UNIX partition already established on the drive. Usually, these partitions are
desired. However, the root and swap partitions are established during installa-
tion. If problems exist with these partitions, you may need to execute the DOS
FDISK procedure to delete these partitions before installation.
V
. SCO UNIX
(T
roubleshooting)