Asus Blitz Formula (Special Edition) - Manual

ASUS Blitz Series technical updates
ASUS Blitz Series Technical Updates
This is an information update for the user guide that comes with your motherboard
package.
2.8.2 Internal connectors (page 2-30)
IE352-c
3. ICH9R Serial ATA connectors (7-pin SATA–6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 5, RAID 10 configuration with the Intel ® Matrix Storage Technology
through the onboard Intel ® ICH9R RAID controller.
BLITZ EXTREME
®
BLITZ EXTREME SATA connectors
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA1
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA3
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA4
GND
RSATA_TXP5
RSATA_TXN5
GND
RSATA_RXP5
RSATA_RXN5
GND
SATA5
GND
RSATA_TXP6
RSATA_TXN6
GND
RSATA_RXP6
RSATA_RXN6
GND
SATA6
• These connectors are set to Standard IDE mode by default. In Standard
IDE mode, you can connect Serial ATA boot/data hard disk drives to these
connectors. If you intend to create a Serial ATA RAID set using these
connectors, set the Configure SATA as item in the BIOS to [RAID]. See
section 4.3.6 SATA Configuration for details.
• For RAID 5, use at least three hard disk drives. For RAID 0, use at least
four hard disk drives. Use two to four Serial ATA hard disk drives for each
RAID 0 or RAID set.
• Before creating a RAID set, refer to 5.4.2 Intel ® RAID Configuration or the
manual bundled in the motherboard support DVD.