Asus P/I-P65UP8/CP6ND - Manual (Page 49)

ASUS P/I-P65UP8 User’s Manual 49
IV. NETWARE DRIVERS
IV
. NETW
ARE
(Installation)
For NetWare v4.xx New Installations
1. Begin the file server installation as per the instructions in the file server instal-
lation chapter in the Novell NetWare Installation Manual.
2. When the NetWare installation procedure prompts you for a disk driver, insert
the Symbios Logic device drivers diskette into drive a: or b:. Then use the INS
key to select an unlisted driver. A dialog box appears. If you are installing the
driver from the a: drive, press Enter to continue. If you are installing the driver
from the b: drive, press F3 (to specify the path to search for the driver), and
enter the drive letter: B:
The SDMSNET4.DSK driver should appear as a selection. Select the driver.
3. Next you are prompted with the available command line options to load the
driver. A description of each option appears in the box at the bottom of the
installation screen. A more detailed description is also given later in this docu-
ment, in the section titled Command Line Options. Select any options needed
for your particular installation.
4. When asked to edit the STARTUP.NCF file, make sure SDMSNET4 is loaded
only once. If present, remove the “port=xxxx slot=xxxx mem=xxxx” options
from the command line.
5. After the installation is complete, if ASPI support is also desired, down the
server and copy the NETASPI4.NLM file to the appropriate server directory.
For NetWare 4.0x systems this directory is SERVER.40 by default. For NetWare
4.1x systems this directory is NWSERVER by default.
Edit the startup.ncf file and add the line: load NETASPI4.NLM
to the file after the line: load SDMSNET4.DSK
For NetWare v4.1x SFT-III Installations
1. Install your primary server following procedures for native 4.1x installations.
2. Begin the SFT-III installation as instructed by NetWare installation procedures.
3. While installing the secondary server, you have the option of copying the
SDMSNET4.DSK driver from the primary server. Press F10 to accept.
4. If ASPI support is required for the secondary server, down the system after
completing the SFT-III installation.
Copy the NETASPI4.NLM file from the device drivers diskette to the
NWSERVER directory on the secondary server.
Edit the IOSTART.NCF file on both servers by adding the line:
load NETASPI4.NLM
to the files after the line:
load SDMSNET4.DSK