Asus RS260-E4/RX8 User Manual

Page 42

Chapter 2: Hardware setup

2-22

8. Take note of the two pegs on the

Riser cage bay. These pegs should

match the holes on the cage to

make sure it fits in place.

PCI cage pegs

10. Match and push the cage card

connector into the PCI-E slot until the

PCI cage fits in place.

11. Ensure that the golden connectors of the riser cage card completely fit the

slot. If properly installed, the top of the PCI cage aligns with the top edge of

the rear panel.

9. Position the Riser cage into the bay

making sure that the pegs go into

the holes on the front of the cage,

and the dents on the rear part match

those on the chassis.