Asus RS260-E4/RX8 - Manual (Page 116)

5-30 Chapter 5: BIOS setup
Item Specific Help
Configures the system state
after recovering from
power failure.
Power On Configuration
Restore on AC Power Loss [Last State]
Power On By PS/2 Keyboard [Disabled]
Power On By PS/2 Mouse [Disabled]
Power On By PME# [Disabled]
Power-On By RTC Alarm [Disabled]
PhoenixBIOS Setup Utility
Advanced
5.4.7 Power On Configuration
This menu shows the power configuration settings. Select an item then press
to display the configuration options.
Restore on AC Power Loss [Last State]
When set to [Power Off], the system goes into “off state” after an AC power
interruption. When set to [Power On], the system turns on automatically after a
power interruption. When set to [Last State], the system goes into whatever was
the system state (on or off) before the power interruption.
Configuration options: [Power Off] [Power On] [Last State]
Power On By PS/2 Keyboard [Disabled]
Allows you to use specific keys on the PS/2 keyboard to turn on the system. This
feature requires an ATX power supply that provides at least 1A on the +5VSB lead.
Configuration options: [Enabled] [Disabled]
Power On By PS/2 Mouse [Disabled]
When set to [Enabled], this parameter allows you to use the PS/2 mouse to turn on
the system. This feature requires an ATX power supply that provides at least 1A on
the +5VSB lead. Configuration options: [Enabled] [Disabled]
Power On By PME# [Disabled]
Allows you to enable or disable the PME and onboard LAN to generate a wake-up
event. Configuration options: [Disabled] [Enabled]
Power On By RTC Alarm [Disabled]
Allows you to enable or disable RTC to generate a wake-up event.
Configuration options: [Disabled] [Enabled]
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →← : Select Menu Enter: Select SubMenu F10: Save and Exit