Asus RS260-E4/RX8 User Manual

Page 134

6-6

Chapter 6: RAID configuration

6. The Create New Array screen shows the disks you can add to make up

the IM volume. Use the arrow key to select a disk, then move the cursor to

the RAID Disk column. To include this disk in the array, press <+>, <->, or

You may also specify the Hot Spare disk here. Select the disk, then move the

cursor to the Hot Spr column, then press <+>, <->, or .

By default, the RAID Disk field shows No before array creation. This field is

grayed out under the following conditions:

• The disk does not meet the minimum requirements for use in a RAID array.
• The disk is not large enough to mirror existing data on the primary drive.
• The disk has been selected as the Hot Spare for the RAID array.
• The disk is already part of another array.

Esc = Exit Menu F1/Shift+1 = Help

SPACE/+/- = Select disk for array or hot spare C = Create array

LSI Logic Config Utility v6.08.05.00 (2006.08.02)

Create New Array -- SAS1068

Array Type: IM

Array Size(MB): ------

Slot Device Identifier RAID Hot Drive Pred Size

Num

Disk Spr Status Fail (MB)

SEAGATE ST373454SS 0003 [NO] [NO] ------- ---- 70007

SEAGATE ST373454SS 0003 [NO] [NO] ------- ---- 35003