Asus RS260-E4/RX8 - Manual (Page 114)

5-28 Chapter 5: BIOS setup
Parallel port [Enabled]
Allows you to configure the parallel port.
Configuration options: [Disabled] [Enabled] [Auto]
Base I/O address [378]
Allows you to select the base I/O address for the parallel port.
Configuration options: [378] [278] [3BC]
Interrupt [IRQ 7]
Allows you to set the interrupt for the parallel port.
Configuration options: [IRQ 5] [IRQ 7]
Mode [ECP]
Allows you to set the mode for the parallel port.
Configuration options: [Output only] [Bi-directional] [EPP] [ECP]
DMA channel [DMA 3]
Allows you to set the DMA channel for the parallel port.
Configuration options: [DMA 1] [DMA 3]
Floppy disk controller [Enabled]
Allows you to configure the floppy disk controller.
Configuration options: [Disabled] [Enabled] [Auto]