Asus RS260-E4/RX8 - Manual (Page 100)

5-14 Chapter 5: BIOS setup
Transfer Mode [Stadard]
Allows you to select the mothod for the data transferring if the hard disk supports
this feature.
Configuration options: [Standard] [Fast PIO 1] [Fast PIO 2] [Fast PIO 3] [Fast PIO 4]
[FPIO 3 / DMA 1] [FPIO 4 / DMA2]
Ultra DMA Mode [Disabled]
When this item is set to [Mode 0-5], the UDMA capability allows improved transfer
speeds and data integrity for supported IDE devices.
Configuration options: [Disabled] [Mode 0] [Mode 1] [Mode 2] [Mode 3] [Mode 4]
[Mode 5]
5.3.6 SATA Port 1/2/3/4
PhoenixBIOS Setup Utility
Main
Item Specific Help
A u t o = A u t o t y p i n g
None = Disabling drive
ATAPI Removable = ATAPI
media (e.g., LS120, USB
Floppy, USB Zip)
CD-ROM = CD-ROM drive
IDE Removable = IDE
r e m o v a b l e m e d i a
(e.g., IDE Zip drive)
Other ATAPI = Other
ATAPI media
User = You supply the
hard disk drive type
SATA Port 1 [None]
Type: [Auto]
Multi-Sector Transfers [Disabled]
LBA Mode Control [Disabled]
32-Bit I/O [Disabled]
Transfer Mode [Standard]
Ultra DMA Mode [Disabled]
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →← : Select Menu Enter: Select SubMenu F10: Save and Exit
Type [Auto]
Selects the type of IDE drive. Setting to Auto allows automatic selection of the
appropriate IDE device type. Select [CD-ROM] if you are specifically configuring a
CD-ROM drive. Select [ATAPI Removable] if your device is either a ZIP, LS-120,
or MO drive. Select [User] to manually enter the parameters of the device.
Configuration options: [Auto] [User] [Other ATAPI] [IDE Removable] [CD-ROM]
[ATAPI Removable]
• Except for 32-Bit I/O item, the following items become user-configurable when
the Type item is not set to [Auto].
• For items that have no sub-menu, you have to use -/+ to change the
values.