GE Industrial Solutions 6KCV300lNS User Manual

Page 29

The parameter 5EFEh is used to control the virtual digital input previously configured; the status of the single
Bits controls the virtual

input assigned to the Bit during the configuration:

OBJECT ATTRIBUTE

MEANING

Index

Value (drive)

virtual digital input

Object code

Single variable

Index of the type of datum

The status of the single Bit controls the

virtual digital input assigned

Length

Password

Access group

2 Byte

Non-existing

Access rights

Write-Ail

Local address

x x x x

Specific

11.2

Virtual digital output

As for the virtual digital output the parameters used to control are:

Parameter index 5EFDh:

virtual digital output.

Parameter index 5EFFh: reading of the values virtual digital output.

Parameter

element array Unsigned Int.

This array is used to configure the virtual digital output; it has to be written before using the virtual digital

output. It has the drive codes assigned to the the output; these outputs are then controlled through the
parameter

type Unsigned Int where the status of the single Bits corresponds to the status of the

virtual digital output assigned during the configuration.

Example:

The elemenf I of fhe parameter array

contains

parameter index

referring to fhe

AV300 drive, which means Drive-Ready.

The functioning is the following: after configuring the element of the parameter

with the

parameter

index

the status Drive-Ready of the the

drive is read fhrough fhe

0 of the

paramefer