GE Industrial Solutions 6KCV300lNS - Manual (Page 27)

S
Parameter not exist
Control Access denied
Attribute Access denied
Type value error
Destination option not exist
Parameter Access Conflict
The specified parameter does not exist
The access is denied because of the control status
The parameter attributes do not allow the access
The specified type value is incorrect
The destination option does not exist at node
The addressed parameter can not be accessed (for example if the command
is write and parameter is connected to an external input)
Value out of the max range Value is out of the maximum range
Value out of the min range Value is out of the minimum range
Value not supported Value is in range but not allowed
Parameter Configuration Conflict The addressed parameter can not be accessed for sistem configuration
Command Submitted
Unknown Command
Read only Parameter
Write not allowed
Value out of constant limits
State not correct
Password
Type Unknown
Hardware Fail
Checksum Fail
NOK generic
conflict (for example try to connect an input source to a that is
already connected to an input source)
Command has been submitted but is not possible to know if it has been
executed
The command is not known
The parameter has read only attribute
Write operation is not allowed for the slave conditions
Value is out of constant fixed
The control state doesn’t allow the command execution
The command is not executed because the password is active
The parameter type is not known
The access is denied because of an hardware failure
The access is aborted because of an error in control
The access is aborted because of an indeterminated error