GE Industrial Solutions Entellisys 4.0 System Test Kit User Manual - Manual (Page 39)

Test Menu 39
1.6.2.2 User Defined Test
This test method allows the operator to change the protection parameters and perform the test
according to the user-intended settings.
Figure 1-18 User-defined Relay Protection Test
Table 1-12 Phase Selectors for pre-defined relay protection test
Type of Test Phases Selected
Over Frequency All Phases
Under Frequency All Phases
Overvoltage Depends on the Phase Requirement in HMI
Undervoltage Depends on the Phase Requirement in HMI
Phase Loss Phase VC
Power Reversal Phase IA, IB, IC
High Current All Phases