Ocean Optics NeoFox - Manual (Page 54)

4: Using NeoFox Sport
44 013-20000-009-02-201203
The following additional steps must be taken once after a flash reset has been performed. These steps are
required to let the device know that it should communicate with the NeoFox Sport DPU.
► Procedure
1. In the NeoFox Viewer software, Select View | Advanced Settings.
2. Click on the Advanced Settings tab in the lower right-hand corner of the screen.
4. Scroll down to the Enable Jaz Interface parameter and set it to Enabled.
5. Set the Flash Write parameter to Enabled. It will remain displayed as Enabled briefly before
reverting to Disabled.
Performing a Single Point Reset in the Field
Once the calibration has been downloaded and the device is in the field, you should always perform a
Single Point Reset before beginning a measurement.