Ocean Optics NeoFox - Manual (Page 47)

3: Using NeoFox with NeoFox Viewer Software
013-20000-009-02-201203 37
2. Enter the name of the file containing the saved setting(s).
Saving Settings
► Procedure
the NeoFox Viewer,
reen.
will remain displayed as Enabled briefly before
reverting to Disabled.
3. rough the NeoFox Sport, select Save Settings from the O2 Setup Menu.
Note
To save these values in
1. Navigate to the Advanced Settings sc
2. Set the Flash Write parameter to Enabled. It
To save these settings th
When the device saves a parameter through a rite, it must save ALL of its savable settings
at the same time. Therefore, actions which ma r to save specific settings to memory will
flash w
y appea
actually save the entire set of savable parameters. Those actions include downloading calibration
data, performing a single point reset, or manually prompting a flash write by setting the Flashed
Write parameter to Enabled in the Advanced Settings Panel.
Resetting Saved Settings
al state.
gate to the Advanced Settings screen.
shortly
thereafter. When the device is reset, the saved values revert to their factory settings.
3.
Note
You can reset the saved settings to their origin
► Procedure
1. Open the device in the NeoFox Viewer and navi
2. Set the value of the Flash Reset parameter to Enabled. This value may revert to disabled
Download your calibrations again after resetting the flash memory.
For devices with firmware version 4.00 or above, the APD Bias Voltage (displayed as DAC-APD
Gain) setting value persists through a flash reset.