Peerless-AV ACC942 - Installation - Manual (Page 8)

ISSUED: 12-01-08 SHEET #: 120-9065-2 08-18-09
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
8 of 25
5
Hand tighten slope nut through 1/4-20 x 1 3/4"
carriage bolt until snug against bottom of desktop
surface. Thread another slope nut upside-down,
about two turns from first slope nut . Insert a open
box wrench between both slope nuts and tighten.
Note: Avoid jamming both slope nuts together,
doing so may make it difficult to remove slope nut
used for tightening first slope nut. After slope nut is
secure remove bottom slope nut and add plastic cap
as shown in figure 5.2. Repeat with remaining
1/4-20 x 1 3/4" carriage bolt .
RUBBER
FEET
Attach lock-down plate to display base bottom using
screws provided. Refer to lock-down hole pattern for
screw placement. Refer to page seven for rubber pad
placement pattern.
Note: Remove existing rubber feet from display base
that interfere with the lock-down plate.
Note: Display base stand and mounting
hole locations may appear different than
illustrated.
DISPLAY BASE STAND
A
LOCK DOWN PLATE
B
4
BOTTOM OF
DESKTOP
FIG 5.1
TIGHTENING
SLOPE NUT
FIG 5.2