Peerless-AV ACC942 - Installation - Manual (Page 13)

ISSUED: 12-01-08 SHEET #: 120-9065-2 08-18-09
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
13 of 25
3.86
11.38
3.35 MAX
12.80
11.80
1.00 1.00
7.25
1.00
4.40
3.54
14.17
1.00
13.17 1.00 1.00
1.18
11.382
Installation Option for (FLD-UNV-LG)
Position TV stand to proper location and mark front of
the stand on the desktop.
Note: Stand may appear different than illustrated.
TV STAND
FRONT
TOP VIEW
Remove screws that hold display to the base
stand as shown below.
2
1
Note: Use this option when optimum security is needed. Brackets may be flipped for more distance from the
edge of the table as shown on page 14 detail 3. Flip TV stand upside down and attach four additional rubber pads
( C) over existing pads or symmetrically.
3
42LG30DC Option 1
#10 x 3/8 phillips self drilling screws ( D)
The width is measured and located 7.08" from center line of display as shown below.
Attach both front lock-down brackets to desktop using two #8 x 3/4 phillips screws and washers as shown in fig
3.1. (supplied in FLD-UNV-LG)
Note: Use the same number of washers for both front lock-down brackets.
Extra washers are included in case additional height is required as shown in detail 1. Two are recommended
for each screw.
Skip to step four on page eleven.
DETAIL 1
DESKTOP
fig. 3.1
Rubber pads ( C)
(PLACE ON TOP OF EXISTING FEET)
BACK OF DISPLAY