Peerless-AV ACC942 - Installation - Manual (Page 21)

ISSUED: 12-01-08 SHEET #: 120-9065-2 08-18-09
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
21 of 25
A
FRONT OF TV STAND
2
7/16"
Slide stand back into front lock-down bracket, then attach back lock-down bracket to desktop using
10-16 x 3/4" penta pin screw at either location 1 or 2 as shown at bottom left. Tighten securely with penta pin
driver.
Note: Use nylon cap covers with 10-16 x 3/4" penta pin screws (supplied with FLD-UNV-LG) when using hole
1 of back lockdown bracket as shown at bottom right.
1
2
TV ST
AND
3
LOCK-DOWN BRACKET
LOCK-DOWN BRACKET LOCK-DOWN BRACKET
STAND BASE MAY BE
DIFFERENT THAN
ILLUSTRATED
Thread four # 10 x 3/8 phillips screws ( D) for option 1 or remove existing rubber pads and screws and replace
them with four #8 x 1/2 phillips screws ( e) for option 2 into front holes, leaving 7/16" of exposed thread.
Flip desktop stand right side up and slide into front lock-down bracket so that screws in front holes locks securely
into slot of front lock-down bracket as shown below.