Peerless-AV WSP820 - Installation User Manual
Warning, Installation and assembly, Parts list
ISSUED: 03-24-09 SHEET #: 125-9057-1
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-729-0307 or 708-865-8870.
1 of 2
Installation and Assembly:
Metal Stud Wall Plate for FPS-1000 or SP850
Model: WSP820,
WSP820-W
A
B
C
D
E
Use a stud finder to locate stud centers. Use wall
plate (A) as a template to mark stud centers
through slots. Drill 3/4" (19 mm) dia. holes through
drywall and studs. Insert togglers (E) as shown
below. Six 1/4-20 x 2.5" phillips screws (D) and six
washers (C) are provided. Place screws (D) through
wall plate (A). Partially fasten the toggler (E) to the
back of the screw. Pivot ends of toggler (E) 90°.
D
C
E
A
Maximum Load Capacity: 150 lb (68 kg)
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
• Make sure that mounting screws are anchored into
the center of the studs. The use of an "edge to edge"
stud finder is highly recommended.
WARNING
A
E
D
E
D
A
D
E
A
C
Push toggler (E) through hole.
Pull screw (D) back until toggler (E) hits the inside of
the metal stud. Fasten all six screws (D) tight, until
wall plate (A) is flush with wall.
WSP820
WSP820-W
Description
Qty. Part #
Part #
A
20" wall plate
1
024-1048
024-2048
B
1/4-20 x 1/2 phillips head screw
4
510-9108
510-9108
C
1/4" flat washer
10 540-9440
540-9440
D
1/4-20 x 2.5 phillips head screw
6
520-9522
520-9522
E
toggler 6
590-1093
590-1093
Parts List