PowerWalker ViewPowerMini - Manual (Page 32)

31
be at least 6 digits) Then click “Apply” button to successfully modify password
for administrator.
NOTE1: Simply click “Login” button on the top right corner to log in the software.
NOTE2: If password is forgotten, it’s necessary to re­install the software.
5.1.2. SMS Configuration
It’s for entering SMS receiver list. In the event of an alarm condition occurring, a
message about UPS status will be sent to the specified users via mobile phone. For the
event receiving list, please configure in “Event Action” column (refer to section 5.1.4).
Step 1 Choose ViewPowerMini Configuration >> SMS. Refer to Diagram 5­2.
Diagram 5­2
Step 2 Select communication port and baud rate.
Step 3 Enter mobile phone numbers in “Phone no.” column and click “Add” button to
add phone no. in Receivers List. To delete numbers, simply select phone no.
from “Receivers list” and click “Delete”.
Step 4 Click “Apply” button to save all changes. The “Test” button can be used to send