PowerWalker ViewPowerMini - Manual (Page 23)

22
SNMP protocol version first. The default setting is V2. If choosing V3, it’s also necessary
to set encrypt. Select devices to apply this setting.
l Select device: Set SNMP protocol version for selected SNMP devices from device
list.
l Select all: Set SNMP protocol version for all SNMP devices from device list.
Then, click “Apply” button to complete version setting.
Part B: You may modify single password for one SNMP device or all passwords for all
SNMP devices. Please enter original password, new password and re­enter new
password. Select devices to apply this setting.
l Select device: Choose to change password for selected SNMP device from device
list.
l Select all: Choose to change passwords for all SNMP devices on the window list
Then, click “Apply” button to change password.
NOTE: The length of password is 8~15 digits. If the password change is applied for all
SNMP devices, it will be consistent for passwords of all SNMP devices.
Static trap address
You may configure two static trap addresses and change trap port in SNMP Manager.
The default trap port is 162. Refer to Diagram 3­17.
Diagram 3­17