PowerWalker ViewPowerMini - Manual (Page 24)

23
NOTE: This software allows SNMP device to send trap messages to 2 static trap
addresses and 8 dynamic trap addresses. It will default define host computer with
software installed as a dynamic trap address. If communication failure occurs between
SNMP card and host computer for over 10 minutes, it will stop sending trap message.
3.3.2. Software Upgrades
Refer to Diagram 3­18 for the detailed configuration for online upgrade:
l Specify the URL for update files: This is the directory to online update
software. Please do not change it unless it’s instructed by software vendor.
l Save files to: The directory to save files.
l Server startup type: If “Auto” is selected, the software will automatically
start up when PC is turned on. If “Manually” is selected, users have to
manually start the ViewPower software.
l Close the window and exit to Monitor: If selected, it will completely exit
software without monitoring service when the window close. If unselected,
it will continue monitoring service in the back end even though close the
window from software.
l Online auto­update: If selected, it will automatically check if there is any
new version launched online every 1 hour.
l If applying online upgrade, please follow below for configuration:
1. Select “Apply the proxy configuration”;
2. Enter IP address and port of server;
3. If ID identification is requested, select “Enable authentication” and enter
User Name and Password.
l Connection test: Click this button to test if all configurations are set up well.