B&B Electronics GW-7472 - Manual - Manual (Page 52)

GW-7472 User Manual, Version 1.0, Dec 2010 --- 52
8. CIP General Status Code
Reference Volume 1: CIP Common Specification Appendix B
General
Status Code
(in hex)
Status Name Description of Status
00 Success Service was successfully performed by the object specified.
01 Connection failure A connection related service failed along the connection path.
02 Resource unavailable
Resources needed for the object to perform the requested
service were unavailable
04 Path segment error
The path segment identifier or the segment syntax was not
understood by the processing node. Path processing shall stop
when a path segment error is encountered.
05 Path destination unknown
The path is referencing an object class, instance or structure
element that is not known or is not contained in the processing
node. Path processing shall stop when a path destination unknown
error is encountered.
08 Service not supported
The requested service was not implemented or was not defined for
this Object Class/Instance.
09 Invalid attribute value Invalid attribute data detected
0E Attribute not settable A request to modify a non-modifiable attribute was received.
13 Not enough data
The service did not supply enough data to perform the specified
operation.
14 Attribute not supported The attribute specified in the request is not supported
15 Too much data The service supplied more data than was expected
16 Object does not exist The object specified does not exist in the device.
20 Invalid parameter
A parameter associated with the request was invalid. This code is
used when a parameter does not meet the requirements of this
specification and/or the requirements defined in an Application
Object Specification.
26 Path Size Invalid
The size of the path which was sent with the Service Request is
either not large enough to allow the Request to be routed to an
object or too much routing data was included.