Baron Air & Fuel_NEEDLE_JET KIT Honda VTX 1300 - Manual (Page 2)

Page: 2 BA-2461-00
BARON Jet Kit Honda VTX-1300
10. Install the Baron needle in place of the stock needle on groove #4 from the top. Use all stock spacers.
Re-assemble the slide and the yellow holder.
11. Insert the slide back into the carburetor, making sure to check that it doesnt bind. There is a small ring in
the edge of the diaphragm to help you align the slide the way it belongs. Re-install the slide cap. Be sure its
aligned properly.
12. You may need to loosen the clamp that holds the carburetor to the manifold and pull the carb slightly off
the intake manifold for the next step.
13. Drain & remove the float bowl from the carburetor. In the center of the underside of the carb is the main
jet. Remove the stock jet and replace it with the Baron 210 main jet (if you have stock pipes, we recommend the
195 main jet).
14. While working inside the float bowl, find the mixture screw (d-shaped brass screw on the edge of the
underside).
15. Using the Baron D-tool, carefully turn the mixture screw clockwise until it seats. It doesnt need to be tight,
just slightly snug.
16. Once seated, turn the mixture screw back out 2.5 turns.
17. Re-install the float bowl.
18. Re-assemble the air box.
19. Re-install the fuel tank.
20. Verify that your choke is OFF before fueling up the bike and testing.
TROUBLESHOOTING TIPS:
Before operating the motorcycle again, verify the handlebars turn freely from lock to lock and that the
throttle cables are not bound up.
If the idle is not set between 700-900rpm tuning will be more difficult.
If the bike idles roughly until its warm, adjust the mixture screw out 1/4 turn at a time until it idles
smoothly.
If the bike stumbles above 1/4 throttle then regains itself, try backing out the mixture screw 1/2 turn at a time
until the stumble diminishes.
If the bike will not start if its hot, this is usually a rich condition. Turn your mixture screw in 1/2 turn.
Due to different altitudes, air kits and pipe configurations, Baron has included a small assortment of jets for
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]