Baron Suspension & Lowering_REAR LOWERING KIT Suzuki Boulevard C90_C90T & Suzuki Intruder LC 1500 - Manual

Page: 1 BA-7580-00
Rear Lowering Kit
Suzuki C-90 VL1500LC
BA-7580-00
WARNING: This installation requires the lifting of the motorcycle. Serious
injury can result from an improperly secured motorcycle. Ensure that the
motorcycle is securely supported during this procedure.
Revision: 1.6 - 06/07/2010
INCLUDED IN THE KIT:
(2) Dog Bones
INSTRUCTIONS:
The use of this product will lower your motorcycle approximately one- to two-inches and reduces suspension travel.
The lowering of either front-end, back-end or both causes the motorcycles chassis, foot pegs/floorboards, exhaust
and other items bolted to any portion of the bike to now be closer to the ground. When turning at both low and high
speeds these items can come in contact with the ground sooner than expected. This contact, should it happen, can
result in possible loss of control or may cause damage to the item. We strongly CAUTION the rider of a motorcycle
that has any combination of our lowering products installed to be aware of the reduction in the maneuvering of
your bike or the damage that could be caused to any of the items referred to above. Baron Custom Accessories
accepts no liability for any damages stemming from the use of these products. We do not recommend a lowered
motorcycle be ridden with a passenger!
1. Decide how far you would like to lower your bike. Refer to the hole-index chart in these instructions to
determine the proper mounting location holes for the drop you want to achieve.
2. Secure motorcycle to bike lift and raise the motorcycle so the rear wheel is unweighted.
3. For easiest access to the linkage remove the tool kit holder from the left side of the bike.
4. Loosen and remove the two self-locking nuts and flat washers from connecting arm bolts from the left side
of the motorcycle.
5. Slide connecting arm bolts out (it may be necessary to push bushing back to the left side to allow bolt head
to drop below frame. Reinstall in the same manner). Replace stock connecting arms with your new Baron
connecting arms. The end with the single hole goes down and attaches to relay arm. The end with three
holes goes up and attaches to the frame. Use the hole that lowers the rear your chosen amount. Reinstall
bolts, washers and nuts. Torque the two connecting arm nuts to 35 foot-pounds (48 Nm). Remove
motorcycle from lift.
NOTE: We recommend that you set the shock spring preload to a higher setting, especially if the motorcycle
will be used for carrying a passenger or heavy loads.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]