Baron Air & Fuel_BIG AIR KIT PINSTRIPE, CHROME Yamaha V-Star 1100 - Manual (Page 2)

Page: 2 BA-2041-00/01/03/06/07/13/13B
BIG AIR KIT - Yamaha V-Star 1100
Insert supplied oil vent tube into crankcase breather inlet found at front of airbox.
Route this tube toward rear of airbox and secure to rear air horn with supplied zip tie as shown.
Install supplied breather foam in rear section of airbox under end of oil vent tube.
Trim foam with scissors as required for a proper, snug fit.
Reinstall top half of airbox and tighten frame bolt and all screws.
MAINTENANCE: Baron recommends the foam filter element be removed and cleaned at each air filter cleaning.
IMPORTANT NOTES: Check all linkages for interference, check all hoses for kinks, check all bolts and
hardware for tightness. Check throttle action for smooth operation before reinstalling the fuel tank.
1. The Baron Big Air Kit (BAK) comes un-assembled. First, place your performance air filter in the groove on
the cover; make sure the filter seats properly to make a complete seal. Now install the backing plate onto the air
filter, Again, align the filter with the groove in the backing plate. Secure with the two supplied 1/4-28 x 1 13/16"
zinc hex head bolts & lock washers. Install the supplied aluminum filter spacers onto the bolts between the back
plate and the cover. Blue Loctite® is recommended here.
2. Loosen the clamps holding the snorkel ("S" shaped air tube) connecting the stock air filter housing to the black
plastic airbox above carbs. Remove the two allen-head cap bolts that hold the stock air filter housing to the
engine and remove the stock air filter housing. Remove the snorkel.
3. Install the snorkel onto the backing plate of your new BAK filter assembly and secure the clamp. Install the
supplied BAK mounting arm to the rear of the backing plate with supplied M5 x 10mm button-head screw. Blue
Loctite® is recommended here.
4. Insert the mounting post from the BAK backing plate into grommet on the side of the engine and secure with
supplied 1/4 -20 nut and washer. Slide the snorkel onto the air inlet on the black plastic airbox above carbs.
Install air filter mounting bolt (M6 x 12mm) through mounting arm and tighten. Now tighten snorkel clamp at
air inlet on the black plastic airbox.
IMPORTANT NOTES: Check all linkages for interference, check all hoses for kinks, check all bolts and
hardware for tightness. Check throttle action for smooth operation.
Reinstall the fuel tank.
Perform final idle mixture screw adjustment per instructions supplied with Barons Jet Kits.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]